Can anyone comment on RSP redundancy with SSO mode?

Casino cemetery records online genealogy. Eg:%CMRP-3-CHASSISMONITORONLINETIMEEXCEEDED: R0/0: cmand: Reloading slot because it has failed to come online Conditions: The module that's failing to boot may have been newly inserted and may have not been upgraded to ROMMON version 16.2(1r) to be consistent with other cards in the router chassis. This older ROMMON will not be. The hw-module slot stop command in EXEC mode automatically stops traffic on the interfaces and deactivates them along with the SPA in preparation for OIR. In similar fashion, you do not need to independently restart any interfaces on a SPA after OIR of a SPA or SIP. Enter the show facility-alarm status command.

I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've done
this:
service single-slot-reload-enable
Slot

redundancy
no keepalive-enable
mode sso
And it doesn't seem to ever sync the slave
ranttest#show red Slot

Redundant System Information :
------------------------------
Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 2
Current Software state = ACTIVE

Hw-module Slot R0 Reloaded

Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Mon 20-Aug-07 16:34 by leccese
BOOT =
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: 3) information is not available because it is in 'DISABLED' Slot

state
ranttest#redundancy force-switchover
Cannot perform switchover until the standby is fully initialized.
The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
not doing anything fancy, so I'm kind of stuck here. The production target
is 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any idea
what might be wrong here?
_______________________________________________

Hw-module Slot R0 Reloadable

cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp

Hw-module Slot R0 Reloader

archive at http://puck.nether.net/pipermail/cisco-nsp/